Alcatel OmniPCX Enterprise R7.1 Manuel d'installation télécharger pdf (Page 76)

3. Connect the negative (black) terminals of the batteries as described below (and shown in

the figure below).

a. Connect the middle connector of the black wire to the negative (black) terminal of

battery B1.

b. If required, connect the end connector of the black wire to the negative (black) terminal

of battery B2.

4. Connect the positive (red) terminals of the batteries as described below (and shown in the

figure below). Note that there may be a small amount of electrical arcing when electrical

contact is made.

a. Connect the middle connector of the red wire to the positive (red) terminal of battery

B1.

b. If required, connect the end connector of the red wire to the positive (red) terminal of

battery B2.

Chapter

  *+

4-32

        

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 191 192

Pas de commentaire

Alcatel OmniPCX Enterprise R7.1 Manuel d'installation Page 76