Alcatel OmniPCX Enterprise R7.1 Manuel d'installation télécharger pdf (Page 132)

Figure 4.73: PATA Hard Disk Connection

___change-begin___

___change-end___

Figure 4.74: SATA Hard Disk Connection

During installation, always take anti-static precautions (wristband, heelpiece, etc.) before

handling the hard disk. Any degradation caused by electrostatic discharges will reduce

the life of the disk.

When going into stand-by mode, wait for the red Power LED to stop flashing before you

remove the module's CPU board. Extracting the disk before the switch to standby is

completed can destroy part of the disk or damage its contents. Never handle the hard

disk until the motor has stopped completely (about 4 seconds after the red Power LED stops

flashing).

4.11.1.4 ADDING AN ADD-ON MODULE

Chapter

  *+

4-88

        

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 191 192

Pas de commentaire

Alcatel OmniPCX Enterprise R7.1 Manuel d'installation Page 132