Alcatel OmniAccess AP70 Guide d'installation télécharger pdf (Page 35)

Port Specifications 31

APPENDIX A

Port Specifications

FE Port

The 10/100 Mbps Ethernet (FE) port is located on the right-hand

side of the OmniAccess OAW-AP70 and has an RJ-45 female

connector. The port pin-outs are shown in Figure A-1 :

FIGURE A-1 OmniAccess OAW-AP70 FE Port

The appropriate cable depends on the level of connectivity

required of the FE port:

z If the connecting device supports Serial and Power Over

Ethernet (SPOE), use an 8-conductor, Category 5 UTP,

straight-through FE cable with a male RJ-45 connector.

The Alcatel 6000 (with Line Card OAW-LC-2G24FP), the Alcatel

2400, and the Alcatel 800 support SPOE.

z If the connecting device supports only Power Over Ethernet

(POE, including IEEE 802.3af POE as well as “inline” or “mid-

span” POE devices), use an 8- or 4-conductor, Category 5

UTP, straight-through FE cable with male RJ-45 connectors.

z If the connecting device does not support Serial or POE, use a

4- or 8-conductor, Category 5 UTP, FE cable with male RJ-45

connectors. The port detects MDI/MDX and automatically

adjusts for straight-through or crossover cables.

AP70

10/100 Mbps Ethernet

RJ-45 Female

Pin-Out

*POE optional

**Serial optional

Serial RxD**

Serial RGND** (POE positive*)

Serial TxD**

Serial TGND** (POE negative*)

ETH Tx+ (POE negative*)

ETH Tx– (POE negative*)

ETH Rx+ (POE positive*)

ETH Rx– (POE positive*)

Direction

Input

Output

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 59 60

Pas de commentaire

Alcatel OmniAccess AP70 Guide d'installation Page 35