Alcatel OmniAccess 512 Spécifications télécharger pdf (Page 18)

OmniAccess Basics 15

OA-512 Management and Port LEDs

CONSOLE

10/100

OmniAccess

512

OK2

OK1

PS (Power Supply Status). This LED displays

Green when the switch is connected to an

AC power source. It is off when the switch

is not receiving power from an AC power

source.

TP (Temperature). If the internal switch

temperature is approaching maximum

operating limits, this LED will display

Green. Note that this LED comes on before

the temperature limit is reached.

OK1 (Hardware Status). This LED displays

Green when the switch has successfully

passed power-on hardware diagnostics. It

displays Amber if the hardware has failed

diagnostic tests. If it is alternating Green and

Amber, file system compaction is in

progress.

Important

Do not power down the switch

while the OK1 LED is alternating

Green and Amber.

OK2 (Software Status). This LED blinks

Green when software has successfully load-

ed and the switch is ready to execute com-

mands. It blinks Amber when the switch is

in a transitional state, such as when it first

boots up. If it blinks Amber for an extended

period of time (i.e., more than a minute),

reboot the switch. If the software was not

loaded successfully, the LED will display

solid Amber.

10/100 Each LED is associated with a corresponding Ethernet

port located at slot 2 (S2). In this figure, the LED labeled 1

(located at top left of the 10/100 LED bank) reports the status

of Ethernet port 1X at slot S2. The LED located immediately

below LED 1 is LED 2 and reports the status of Ethernet port

2X at slot S2, etc. Refer to page 13 for slot locations.

An LED displays Green continuously when a good cable con-

nection exists on the corresponding port. The LED then flash-

es Green when traffic is detected on the port. If the LED is off,

a cable is not connected to the corresponding port or the con-

nected cable does not have link integrity.

1 2 ... 13 14 15 16 17 18 19

Commentaires sur ces manuels

Pas de commentaire

Alcatel OmniAccess 512 Spécifications Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs de réseau Alcatel OmniAccess 512