Alcatel OS6850-48 Guide de l'utilisateur télécharger pdf (Page 93)

OmniSwitch 6850 Series Chassis and Hardware Components Console Port

OmniSwitch 6850 Series Hardware Users Guide April 2010 page 2-69

Console Port

The console port, located on the chassis front panel, provides a console connection to the switch and is

required when logging into the switch for the first time. By default, this RJ-45 connector provides a DTE

console connection.

Serial Connection Default Settings

The factory default settings for the serial connection are as follows:

Modifying the Serial Connection Settings

The switch’s serial connection defaults are listed above. If you wish to modify the default serial connection

settings (i.e., baud rate, parity, data bits, and stop bits), refer to the following steps:

Note. You must be connected to the switch via the console port before attempting to change serial connec-

tion settings. Otherwise, an error message will display.

For switches in a stacked configuration, all changes must be configured before the switches are cabled

together. In other words, you must configure these settings when each switch is operating as a stand-alone

unit.

1 Enter the modify boot parameters command at the CLI prompt. The boot prompt displays:

Boot >

2 To change the baud rate, enter boot serialbaudrate, followed by the desired baud rate value. Options

include 1200, 2400, 4800, 9600 (default), 19200, 38400, 57600, 76800, and 115200. For example:

Boot > boot serialbaudrate 19200

Note. Setting the console port to speeds above 9600 baud can cause problems with Zmodem uploads.

3 To change the parity value, enter boot serialparity, followed by the desired parity value. Options

include none (default), even, and odd. For example:

Boot > boot serialparity even

4 To change the data bits (i.e., word size) value, enter boot serialwordsize, followed by the number of

data bits. Options include 7 and 8 (default). For example:

Boot > boot serialwordsize 7

baud rate 9600

parity none

data bits (word size) 8

stop bits 1

flow control none

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 191 192

Pas de commentaire

Alcatel OS6850-48 Guide de l'utilisateur Page 93